Search Forums


Tips for better searching

Saxophone Forum

Forum » Sax Repair » To fix an bell brace without a screw


by johnsonfromwisconsin
(767 posts)
18 years ago

To fix an bell brace without a screw

Hi again, As I may have mentioned, that YTS-21 I have doesn't have a bell brace screw and it doesn't look like I'll be able to readily find one. Yamaha's woodwind parts division doesn't carry them anymore and I haven't been able to find any parts. I am tempted to solder the bell brace in place and attach merely the head of an appropriate looking screw in place for asthetics. Would you call this a proper repair proceedure if this horn was to be resold (with full disclosure, of course)

Reply To Post [Report Abuse]

Report Abuse
Replies


  2. by Dave Dix
    (421 posts)
    18 years ago

    Re: To fix an bell brace without a screw

    Dont solder it just find a 4mm(i think) screw or bolt and cut to length, this will do until you can get the correct one Dave

    Reply To Post


    1. by johnsonfromwisconsin
      (767 posts)
      18 years ago

      Re: To fix an bell brace without a screw

      Yep, 4mm. I found a few 4mm machine screws of different lengths, bought them for less than two dollars (considering they were in packets at their various lengths) and they work fine. Thanks :)

      Reply To Post